For real. Everytime I get in the shower I end up having to point the showerhead away and cower from the cold water and I could have just turned it on first?

  • I’m so thrown off by our current shower which legit heats up in 2 seconds. I was so used to waiting like a minute for it to warm up, I built my rituals around that. But this one… it’s just hot, like right away. Bizarre

    • @MystikIncarnate@lemmy.ca
      link
      fedilink
      English
      110 hours ago

      I think some of the really fancy installs have a secondary tankless water heater for the shower…

      I think I saw that somewhere.

          • DosDude
            link
            fedilink
            141 day ago

            It’s just dumb engineering to heat up a pipe the entire day for the 0.8% of the day you need it to be hot.

            • @Honytawk@feddit.nl
              link
              fedilink
              26 hours ago

              Heat pumps generally use a lot less power. Don’t need to heat up much if it is already slightly hot.

            • FackCurs
              link
              fedilink
              113 hours ago

              It’s typically used for large complexes like campuses where the hot water is made en masse in one building and the loop goes around all the other buildings. Helps keep cost down (at construction) because you only need one giant water heater. Helps not have to wait 10 minutes to bring the hot water to your building. Energy still gets wasted but given the number of users, not that bad.

            • snooggums
              link
              fedilink
              English
              231 day ago

              Insulation + retaining heat means it isn’t nearly as energy inefficient as you think.

              They keep the water tanks heated all day, and not heating the pipes means they have to do more work as they are drained of more water to fill the length of pipe to the shower which will then lose that heat over the course the day, only to need the water heater to heat it back up again.

            • @aubeynarf@lemmynsfw.com
              link
              fedilink
              4
              edit-2
              24 hours ago

              You don’t have to heat it up all day. Did you just post the first “anti” thought you had without giving one minute of consideration to how modern controls work?

              • DosDude
                link
                fedilink
                124 hours ago

                Have you read the previous comments? Because that’s exactly what’s implied.

        • @papalonian@lemmy.world
          link
          fedilink
          341 day ago

          Someone else already pointed out that these are usually pretty well insulated systems that don’t radiate much energy, but also consider how many dozens of gallons of water aren’t being wasted by waiting for it to be warm.

          • @BossDj@lemm.ee
            link
            fedilink
            9
            edit-2
            1 day ago

            Nearly all of these systems are put on timers. So they stop cycling while you’re at work or over night. They’ll often make it a part of the smart home ecosystem as well, so you can override from a smart home device or phone

        • dohpaz42
          link
          fedilink
          English
          181 day ago

          If you have a hot water tank, that hot water is just sitting there getting cold just waiting to be heated up again. A circulating pump puts that hot water to use by circulating it through the pipes, which has a nice side effect in cold climates of preventing the pipes from freezing and bursting. I doubt it wastes much energy as you think.

          • @aubeynarf@lemmynsfw.com
            link
            fedilink
            424 hours ago

            Hot water tanks do not just “get cold”; they are fantastically well insulated. And a great way to lower peak energy usage by accumulating heating power, making it possible to use a heat pump to heat the water.

            • @BastingChemina@slrpnk.net
              link
              fedilink
              321 hours ago

              Hot water tanks are usually not that well insulated. If you want to save electricity an easy thing to wrap a good later insulation around it.

    • snooggums
      link
      fedilink
      English
      261 day ago

      The distance from the heater to the shower is usually the biggest factor.

    • Kualdir
      link
      fedilink
      English
      171 day ago

      Same here! Moved to an appartement so everything is closer and now I don’t need to turn on the shower 5 business days before I want to shower

      • @applebusch@lemmy.blahaj.zone
        link
        fedilink
        English
        111 hours ago

        Some apartments with central hot water have a recirculation pump, so the water is almost always hot. My building has one. The water is always hot, but for some fucking reason the hot water is like right next to the cold water, but the cold water doesn’t have a pump, so the cold water pipes will get hot from the flowing hot water. Then when I turn on my shower the cold water will be just as hot as the hot water… for like a minute, making the entire thing fucking pointless because you still have to wait to get in. But I can burn myself on demand so I’ve got that going for me.

        • Kualdir
          link
          fedilink
          English
          16 hours ago

          I have my own water heater. Its an older appartment 😅 but that does sound quite inconvenient wow